XRAY - Model racing cars

Hello from France,

some of you wanted some explanation.

First, I cut the arm of #302516.
I drilled a hole and screw a long ball #302653 with some shims to make the steering linkage the more horizontal possible. For the servo saver, I put the same long Ball #302653 with shiming a lot to put the linkage paralel to the servo.
So, the linkage is made with two long balls #30653 + two cups #302663 (little shortened) + a screw 3x20mm instead of # 302630.

On the steering rack, I put the short balls #302652 with the shim for Ackermann. I apply a light treatlock to secure.





I will try to put the linkage on the other side. It will be longer and some racers said "it's better."

Au revoir

anyone no if there's a way to do this t2 008 because ive only seen it on a t3 11 with the exception of the one with a different steering setup