XRAY - Model racing cars

Hi
I've got SP Cirtix and 13.5r motor
and when i calibrate it as it is written i manual
i does not want to work
after all this calibrating i turn off the ecs,turn on again and i pull the trothle stick and nothing is happening!
pls help!

you need to wait like 3 seconds , the itrix is stupid and takes some time to load up

if you have done it as per manual then it WILL work

i did wait even longer...
HELP!

i fixed it

How?


Could you explain what was wrong and what you did to fix it?

When i click this set button and then i haer some sound and after that i gave trothle
the vaild way is to give trothle etc while you hear the sound

ok set up procedure is

set end points on your transmitter to 100% throttle and brake

press button on speedo , turn on , hold button till it beeps then release

leave transmitter in neutral position , press button (one beep)

pull full throttle on transmitter , press button (two beeps)

pull full brake on transmiter , press button (three beeps)

turn speedo off and on , wait for boot up and it is learned in

simple

Connected my SP 13.5 to the Cirtix Speedo

Is it normal for the orange led to remain on and the red flashing when the car is on neutral?

And when on throttle the red blinking only?

Thanks

Yep that is normal

All ROAR spec speedos hace the flashing light at neutral to say 0 timing mode