XRAY - Model racing cars

So this weekends BRCA national look like its going to be wet for at least
some of the weekend.. What does anyone do with regards to waterproofing
their Xray's.

Any Pictures and advice would be great..

this was my idea ,

added putty to the sensor wire area on the motor and the servo was painted in shoego type waterproof silicone sealer

I filled the box with toilet roll and this absorbed the water thet got in just needed to replace the roll every quali or race

my set up is here too



worked well

also try to get some Simple green universal cleaner , we were smearing my tyres all day and warming them , i was having grip roll issues at one stage LOL

I took the receiver circuit board out of it's case and covered it in waterproofing spray.
The ESC box also has an extension that come out through the side so I can remove the ESC and it's signal cabling stays put.
It also has some silica gel packs in it and hasn't been opened in 9 months

Cool Ideas... Keep them coming

here is my water box it is going to have a sanwa 2.4 ghz reciver and a sxx or a tekin rs pro

Very nice electrics install steven and cool box

post picture when its installed

Oh right, ive thought about using these lockable sandwich boxes, with the rubber seals in.
Drilling some holes etc etc and gunking them up, least then i will be able to gain access to the esc for fine tuning.