XRAY - Model racing cars

Hi all!, i have a doubt about the basic setup, the screws used for flex setup:

Basic setup screws: have all screws in upper deck (include the red circle)
File comment: Basic setup flex screws

base_setup.jpg [ 26.73 KiB | Viewed 1442 times ]


flex setup screws from manual: there is no configuration that has the red circle screws
File comment: flex setup screws

flex_settings.jpg [ 155.88 KiB | Viewed 1442 times ]


To the basic setup, this screws used or not used?, i'm very confusing about that screws?

thanks! regards!

Seems to be a mistake on the basic setup sheet because I'm not sure its advisable to remove those screws (ones circled).
As far as I am aware, the only screws that should be removed/added to adjust flex are the ones shown in pink on the multi-flex setting sheets.

Cheers
Andrew

Thanks for you quick reply! ... mmm but these screws are not in the flex-setup pdf?
I think that these screws are fixed as you say! and the only screws to put/remove for flex chasis are the filled circle pink!
Suggest to correct error:
- basic setup.pdf: not put these screws to removable
- flex setup.pdf: draw these screws to fixed
is this correct?

Regards!

Hi,

yes you are correct, these screws are fixed and only those in pink circle can be put/removed

We made a mistake in flex set up and we will fix it but in basic set up it was made by purpose because even though we do not recommend to move with these screws, the customer can in some specific conditions.