XRAY - Model racing cars

I am having issues, When I make a turn to the right at a high speed my car traction rolls. The car shocks are set to factory specs minus the springs are 3.0 fronts and 2.4 rears. The rear toe is 1 toe, everything else is per the factory setup. I have added some weight to the battery side to balance the car. I am running a spec Jaco Blue tire. Thanks for the help.

Mike

Soften your springs, especially the fronts. A White Front/ Yellow rear would probably work very well. You need to let the the suspension compress and the chassis lean or roll more into the corner. Thicker damping, a lower roll center, and softer sway bar on the front end will also help.

use harder compound of tires

carpet or asphalt?
It only traction roles when turning to the right?
U sure the chassis is balanced?

Cheers
Andrew

Add more rear toe in.

Use the 2.6 rear and 2.8 front springs as a starting point.

Put less overall downtravel front and rear.

Make sure that the car is tweaked correctly by lifting the chassis from the set-up board with a tool or a knife to see if the tires are lifting simultaneously from the ground. If not, adjust with downstops or preload on the springs.