XRAY - Model racing cars

hi guys im after the same setting i ran on the old car but havent got the old one to match up or have a set up system to hand. anyone know how much shims i would need to get this effect on the new car



Uploaded with

note in pic steering post in rear hole and ackerman clicker in position 3

Just set your steering straight ahead on the 10 and see how straight or angled the tie rods are in relation to the servo saver and the steering block, then transfer this angle over to the 11. Or use setup guages and pick a right turn reading like 20* on the right tire, and read what the left tire is at, then go the opposite, swap left and right, (this should be the same both directions). Then simulate the same procedure on the 11, adding on subtrating shims till you get the same results.

"but havent got the old one to match up"

I've got the 11 car and the setup gauges, so can measure that when you know what the 10 car does.

I have checked both cars and the 1mm ackermann shim on the T3'11 seems to have the same settings as the 3rd notch & inner ackermann position 2 on the T3' 10.

ok thanks for your help
strange thing though it doesnt feel like the old setting