XRAY - Model racing cars

Looking to the updates of the new car, would be a conversion kit to update the "old" T3 to the new T3 2011?

Looking close to the car, the only what we need is a chasis, top deck and dual steering system shock membranes, and lipo holders, is that true? I think the entire car is the same except this parts.

I'm sure we would apreciate a conversion kit.

I really hope so. Buying these few individual parts would likely come in at £140-150 which is silly expensive. I'd be happy to pay £99 though. Unfortunately, I cannot remember XRAY ever doing this. But times are different now and I'm sure people wont be doing what they did in prior years and using Ebay of old car + cash to make the leap as there just aren't the wealth of buyers anymore.

It seems like we will need:
Chassis
Top deck
Servo Saver
Steering System
New Shock Membrane
New Stickers
Lipo Battery retainers
(Will it need new new steering rods and ends?)

Fingers crossed!

Xray did do a conversion kit from the T2 to the T2'007 but the cost of the kit was £140.00

http://www.redrc.net/2006/12/xray-t2007 ... ions-sets/

But this conversion kit is almost a whole car... From T3 to T3 11 there are less parts changed.

Hi,

I found these parts are needed to convert it 100%, the problem (at least in Norway) is that this amounts to over half the price of the new car. I think it's better to buy the new one and use the old as spare parts.

30 2516
30 2535
30 2541
30 2545-O
30 2506
30 2653
30 8081
30 8091
37 2502

You don't say what those parts are, but there looks to be too many to me.

You also missed out the chassis!

Skiddins

If you want to convert your XRAY T3 to T3 2011 than you will need #301131 chassis, #306184 lipo battery backstops, #301192 top deck and #302506 steering system set. All these new parts should be available within few weeks. Also you can get the #308081 lower membranes and #308091 lower shock foams to upgrade the shocks.

Can i convert my T3 US foam spec completely to T3 2011 using the Xray T3 to T3 2011 Conversion kit (#300945)?

http://www.teamxray.com/teamxray/produc ... catName=T3 2011 - Conversion Set

There IS a conversion kit - # 300945

All the bits you need are in there. (Just finished converting mine...)

Yes, that's the conversion kit that I will be getting...
But I noticed that my T3 US foam spec is using 50mm shafts onthe front and back while the T3 2011 is using 52mm... Can I use the 50mm shafts in the T3 2011 conversion kit?

you can