XRAY - Model racing cars

Hello Mader.

Will those MP9 center drive shafts fit both the '09, and the 2mm extended '10 chassis?

The standard Xray '09 rear shaft can after what I understand also be used on the '10 chassis (then even stops the dogbone hitting the center diff during hard impacts with terra fima!).

Ronny

Well Ronny I have only done this mod on the 2010 so I cant say where the pin would end up on the 09 spec. Right now the pins line up with the disc on the center diff outdrive which is perfect. Im sure you would have to find a shorter rear shaft to prevent that terra firma thing you were talking about. Good luck!

Let me know if I can help further.

Mader I would like a set of the bearing spacers

I have 1 set left if anybody else wants any. I don't plan on making anymore.

808 mod proves to be the cure. Had a few other Xray drivers at the track last weekend that could not believe the difference in how smooth the driveline is compared to stock. I took it apart after the third race just to check things out but there was really no need. Everything looked perfect, just like my ol Tq.

Hey Mader I could definately use a set as well. Could ya whip up another batch for those that still need them, thanks!

Give me a week or so to get caught up at the track. I will probably make some this weekend as alot of people are wanting them now. I will post something when there ready.

I have 2 sets of sleeves made. If anyone wants them send me a message and I will send you a link.

I would say just use the XB8/XT8 bulkead, BUT I really like that you can slide the middle drivetrain out of the diff case, so the sleeves make sense at least in that respect.

Sure would have been nice to see an 808 in the show at the worlds. Quite a disappointment for Me.