XRAY - Model racing cars

Hi I had my car pretty much where I wanted it last night at my local club.

The only issue was grip rolling on corner entry , high speed corners slowing and entering a corner. Has any one any ideas on how to cure this? I thought of anti-dive/ raising roll centre but do not want to lose the steering I have for the rest of the corner.

I have recently installed a gear diff and have 60wt oil in which is very thin, if this was thicker , say 2000, do you think the diff would push the car more, rather than letting it turn in so hard?

cheers in advance,

M

I would raise the front roll centres at the pivot pin.

Also consider trying softer springs front and rear.

Skiddins

Post your setup. This is on carpet right? ?
Going wide front and rear always helps. I run my carpet cars at 189mm wide front and 187/188mm wide in the rear.

This is the set-up I used, do you think the rear diff being 'loose' would affect this?

xform/index.php?act=view&ID=2196&setup=t2_008

use thicker gear diff oil/grease, this will help alot

Go wider at the wishbones.

I use 1.5mm shims and the high roll centres.