I know this has been a much talked about subject. There is one thing i cannot find anywhere in the forum. I am using a ride height gauge to set my droop. I have my ride height set at 5mm at all four corners. I take my ride height gauge and set the chassis on the 6mm step. I screw my downstops until i can pull a piece of paper from under my tire with no resistance. Now I have 1mm droop, I think. I am only doing it this way because i don't have a droop gauge. Can i do it this way or do i need to get a droop gauge. Also i need to know if my ride height is 5mm, what is a good recommended droop amount to start at? Any help is greatly appreciated.
|