is T3 Rear toll in not symmetrical (one degree)?

gtimax · **Posted:** Mon Mar 15, 2010 12:33:25

I built a brand new T3, I measure the rear toll in on Hudy setting board, I found it is one side 3 degree and the other side is 2-2.25 degree! (I measure another brand car is perfectly 3 degree left and right)
is it something wrong of the new arm mount or chassis?
thanks!

Martin Hudy · **Posted:** Mon Mar 15, 2010 16:25:24

gtimax · **Posted:** Mon Mar 15, 2010 16:36:19

Martin Hudy · **Posted:** Mon Mar 15, 2010 18:21:24

sidecarphil · **Posted:** Mon Mar 15, 2010 20:35:53

Twin-Kyle · **Posted:** Mon Mar 15, 2010 20:56:21

JayL · **Posted:** Mon Mar 15, 2010 23:33:05

Martin Hudy · **Posted:** Tue Mar 16, 2010 09:29:21

gtimax · **Posted:** Wed Mar 17, 2010 17:11:36

ok I try to install and check it again according to Mr. Hudy's advice first , then I will report it tomorrow!
thanks guys!

FOXY923 · **Posted:** Wed Mar 17, 2010 20:58:13

Has this problem not been going on since the original T2?

boosta1276 · **Posted:** Sat Apr 17, 2010 15:56:03

i had exactly the same problem with my 009 2.5 + 3.0 and found that it was the upright throwing the rear toe off. i changed the upright like for like and i have equal toe with equal shims, it seems the upright that was on the car must have been +0.5 instead of 0 :roll:

g26er · **Joined:** Wed May 19, 2010 20:45:48 **Posts:** 7

For those that have had this problem and have since got the new 1pc rear forward mount, have you measured your toe again?

I'm wondering if the holes in the 1pc are offset to match the holes in the chassis.

XRAY - Model racing cars

is T3 Rear toll in not symmetrical (one degree)?

Who is online