XRAY - Model racing cars

Do you have a setup sheet we can look at? I just wonder if you have widened the front end at the pivot pin mounts, I don't think the Hex increase is buying you the effect your looking for.

I am not sure the exact weight springs I have on without looking at my car. I know I went heavier in front because my inside rear was lifting on tight turns. Rear is 17.5lbs or 20 I think. I am running 350 weight oil. My shocks are not idea yet but are close. They are one of the last things I change. What I have works, but I am always looking for an extra .1 seconds.

Change the roll centers then go from there. Not being able to change tires makes things difficult as that is the most obvious thing to change. I run softer front tires than rear to offset the understeer I had with roll center changes.

FYI, running 13.5 brushless spec, but changes to setup apply to all.

Here is the meeting from Jan 3rd that I had grip roll at, I run 10.5 but the video is one of the Mod A-Finals, the orange car at the front is Elliot Harper's Tamiya.



Skiddins