Joined: Sun Jan 04, 2009 23:57:20 Posts: 8 Location: Madison,WI
|
I have been using a friends Spool in my fron end to test against a oneway. the problem im having is the screws that hold the outdrives into the spool were too short so I had to use longer ones then what comes with it but the out drive still comes loose and I end up with 3 wheel drive 1/2 way throught a race. the spool is plastic and if I tighten the screw too much the put drives get jamed on the berring cups and the spool wont turn. is there a cure for this or is the spool just not ment for the car
|
|