Which switch fits?

arboleda · **Posted:** Sat Apr 18, 2009 18:21:09

I've measured the center of the screw holes for the spot where the switch would go and it appears to be 15mm. I then searched a few online shops but they don't appear to list this measurement.

Anyone have a model number for a switch that will fit? I'd like one with a charge lead as well.

For those of you who don't run the switch, are you simply popping the rubber crystal cover off and plugging your battery in? That seems tough to me...

Roelof · **Posted:** Sat Apr 18, 2009 19:02:06

arboleda · **Posted:** Sat Apr 18, 2009 20:45:19

musti72 · **Posted:** Sat Apr 18, 2009 20:58:50

KWT-NT1 · **Posted:** Sun Apr 19, 2009 00:11:10

Delboy · **Posted:** Mon Apr 20, 2009 08:18:26

I also agree with Roelof, best to use a Futaba connector. I haven't seen anyone at our club with a awitch. They can vibrate from the ON to OFF
position

Nikos Georgiadis · **Posted:** Mon Apr 20, 2009 08:29:18

I don't have seen anyone that uses the switch. I ' agree with Delboy. :wink:

marvcat1 · **Posted:** Sat Jun 06, 2009 15:53:10

calvin · **Joined:** Thu Sep 09, 2004 14:56:44 **Posts:** 42

XRay at one time sold a Receiver Switch Set Part #336060 which worked with the NT1 and could be mounted in the receiver box but I don't know if it is still available. The set included a rubber cover for protection against the elements and it could also be opened and rewired to add the charging function when in the normal "off" position (i.e. in the normal "on" position power is supplied to the electronics, in the "off" position you can charge the batteries).

I have used this switch in our NT1 in the above modified configuration with absolutely no problems for a number of years.

brano · **Posted:** Fri Jun 12, 2009 13:15:42

The is still available in fits perfectly XRAY NT1 cars.

XRAY - Model racing cars

Which switch fits?

Who is online