XRAY - Model racing cars

Please refer to the Lipo conversion instructions on the T2'009

My LRP 5300 Fitted:







Excuse the mess and fluff on the car, was racing on carpet and haven't had chance to clean it!!!!

I basically placed 1mm shims under the top deck to raise it and shimmed the servo saver too. Then it fits fine with no sanding! And sits flush to the chassis.

Then soldered a standard corrally style connector with a flat piece of wire under the top desk as you can see because the terminal wetn under the top deck when it lined up with the cell placement. Hope this helps.

Matt