Hi Mr T.
I am currently racing a T1FK. I had a frame made to fit LIPO saddle packs. This frame will hold the LIPOs. One lipo (Servo side) will we placed were the old cells went, but the other one is slided towards the front, so I can fit my ESC in between the motor and the Lipo pack, thus having a small high current loop, to avoid interference with the receiver (taped onto the servo).
------------------------------
- **** ******* ****** -
- * M * * ESC * * LIPO * -
- * O * ******* ****** -----
- * T *
- * O * ******* ****** -----
- * R * * LIPO * * SER * -
- **** ******* ****** -
-----------------------------
As you can see, the weight balance is off, compared to the old cell setup, where the heavy cells were near the back of the car.
Hope the drawing sheds some light on my setup.
I was hoping on someone to tell me where the weight center is located on their car, near the front or back, so I can add adequate weights to correct the offset.
Thx
|