XRAY - Model racing cars

I think in the manual they show the tensions set in the middle for front/rear. The side belt is left to you.

As for what the different settings do, now that's information I haven't seen discussed in the manual or setup book.

Hi ToysRUsKid,

I cannot translate exactly your reply into my language.

My question was how strong or weak the 3 belts on the NT1 should be tightened.

In the meanwhile I had a glance on some technical books and I found out that belts (in real life and perhaps in RC-cars too) are tightened pretty weak.

So a belt should bent more or less when tipping on it with a finger.
For the rear and front belts I'll propose 5 mm (0.2''). And for the middle belt I propose 10 mm when the tensioner is in contact with.

How do you think about?

Best regards,

Hamfri