CASTOR

MR JOLLY · **Posted:** Wed Sep 22, 2004 09:26:22

tonyv
So what srings would you start with outdoor,rubbers or indoor t27`s
I will go out with light blue`s all round & go from there

Tonyv · **Posted:** Wed Sep 22, 2004 10:00:57

White or light blue all round are generally good staring points.

MR JOLLY · **Posted:** Sat Sep 25, 2004 19:15:39

Tonyv · **Posted:** Sun Sep 26, 2004 21:31:08

Yes, assuming you have the FK bulkheads. With these you should have three holes to mount the front and rear pivot pin holder. This goes for both the front and rear bulkheads. Assuming you have the rear pivot in the bottom hole, the middle hole at the front will give a 1.5 degree angle and the upper hole 3 degrees.

MR JOLLY · **Posted:** Sun Sep 26, 2004 22:43:40

Thanks tonyv we are getting there

,next question
Q)1, why did`nt x-ray mill out the rear of the xrc chassis to use the lower holes in the rear bulkheads(FK) :?:

Q) 2, since i can`t use the lower holes in the bulkhead, if i put a 1mm spacer under the rear ball joint on the rear hub,Is this a good subsitiute :?:

Tonyv · **Posted:** Mon Sep 27, 2004 13:51:30

MR JOLLY · **Posted:** Mon Sep 27, 2004 16:36:35

Tonyv · **Posted:** Mon Sep 27, 2004 17:17:50

XRAY - Model racing cars

CASTOR

Who is online