!Who Knows the Most!

brano · **Posted:** Tue Jul 22, 2008 09:21:16

1) D diff washer is used only in composite diffs, for your T2'008 alu ball diff you will need the

2) The axial shims should be flat and without scratches so the ball in the axial cage move freely. If you have groove on the shims than I suggest you will replace the axial #930138.

WEST · **Posted:** Tue Jul 22, 2008 10:01:52

Thanks for the part number on them washers

The grove has not been done by poor maintance or the bearings
its been machine in?

i just need to know which side goes against the bearings the the flat flush side or the machined side witha grove?

brano · **Posted:** Tue Jul 22, 2008 16:49:11

The axial shims has NO groove - both sides of 7.8mm and 8.0mm shim should be same and flat. Could you send photo so I can check it?

WEST · **Posted:** Tue Jul 22, 2008 17:57:46

ok no problem can you pm me your email adress and i will send you some photos when i get back from work in a couple of hours time

WEST · **Posted:** Wed Jul 23, 2008 09:56:39

YELLOWSHARK · **Posted:** Wed Jul 23, 2008 14:13:14

WEST · **Posted:** Wed Jul 23, 2008 14:42:02

Phil C · **Posted:** Wed Jul 23, 2008 21:34:05

WEST · **Posted:** Thu Jul 24, 2008 09:43:04

brano · **Posted:** Thu Jul 24, 2008 14:01:10

The axials in the diffs are same from the first T1 till the new T2'008 and XRAY does not offer the axial shims with groove, please check this photo

WEST · **Posted:** Thu Jul 24, 2008 16:13:48

thats wired i will buy the new part i will get some photos take and send them to you?

XRAY - Model racing cars

!Who Knows the Most!

Who is online