XRAY - Model racing cars

Thanks to all those that are truly trying to help and not insulting.
Bren - Thanks for putting up a setup sheet on the NORC track. I will try it before putting the BridgePort to the Aluminum hubs. Here is the track I am talking about. http://www.dmspeedway.com/track.html Any more suggestions would be appreciated.

+1 on dremeling the c-hub to get more throw. I also use the aluminum knuckles which has a more recessed joint. That and 7K diff oil in the front, I can steer inside any truggy out there.

PS I also use the Proline LPR series of tires.

Didn't mean to sound insulting mate, if you're talking about me that is. I did ask a series of questions in which I got no response though to try and help you out...........

Cheers

Apology Accepted.

Be careful Ralph, it looks like you're from KS and run on a typical American track...

Dremel the steering hubs, c-hubs, arms and the back of the upper pin holder to get more steering throw. [See pics below]

And copy this to the 'T'.

I live and race here in TX, so our tracks should be similar.

Steering throw mod on my old buggy, but the same principle as the truck...

Ralph

Be carefull as Rocco says this because norc track setup i posted is for the uk track which is astro turf.
If it was a dirt track my set up would still be the same, just decide your driving style & work on setup from there.
Remember though guys posting about using thick diffs drive on power & this helps to pull truggy around in the corners.
If you drive in an off power style like me go thinner diffs

Bren