XRAY - Model racing cars

Call Mario my name?!?!?!

I knew exactly which screws you were talking about, and yes the heads on my screws wobble just a little in my screw gun, but the shafts (the thing that matters) is straight, but Mario would be the guy you need to talk to about this, but there shouldn't be a problem at all.

And on the bottle topic I know, constructive criticism was at play, but seriously, a bottle top?! Something they most likely outsource...

Wow I don't even want to think about how many Xray's I've built, haha! Just for kicks...

2 - T1 - Freedom of Choice Cars
3 - T1FK'04's
1 - T1FK'05's
5 - T2's
4 - T2'007's
1 - T2'008
2 - XB8's
2 - XB8TQ's
2 - XB8EC's
1 - XT8
2 - 808's

I'm an animal....

Only one of the screws in holding the the rear bulkheads was bent in my kit...and it was BENT in the middle of the screw, not just the head being offcenter.

Your killing me! Call me later or when you get a chance lets talk lol!

In regards to the screws, I feel somewhat responsible for this thread as I am the one who brought this to rob's attention. I had to take my wife's diff case back apart because she did not seat the inner pinion bearing all the way. This is when I noticed the screws were bent. I am 100% sure they were straight when they were installed. Im sure its the installation of the control arm screw and nut assemblies that cause the stress that bends the screws. Obviously once the whole thing is on the chassis they don't matter anywaybut I agree with Rob that It reflects on quality and those of us that know him know that nobody GEEK'S harder than him over Xray quality.