XRAY - Model racing cars

Hulk, just get the 3PK. When will you be needing 4 channels on your truggy anyway? Plus you can always switch modules when you wanna use HSR spec recievers

I read the same thing. suggestions were to vent the reciever/battery box, remove the switch (if you have one), and separate the reciever as far away from the battery as possible. If you have a Lipo reciever pack with a regulator, move the regulator to the outside of the box.

If your running digital servos,,try to eliminate the neutral position buzz as much as possible.

Futaba is currently looking into it the overheat problem.

I am running a lipo with a regulator mounted outside, top dollar JR digital servos, and a inline switch, so far so good with no problems. Hope it stays that way.

I have been running with Keith's same setup but my regulator inside the box and problems. It got very beat up when outside and I could not find a way to mount it and have it stay put.

Should I put it back on the outside of the box?

we run an m11 right now but it feels slow to me. was looking at the jr z1 i think...3 year warranty hard to beat. tried one at the track and is was fast.