Problem with rear toe-in in my XT8

daz.fx · **Posted:** Fri Feb 29, 2008 23:57:39

First i have to suggest the obvious (sorry), check the inserts are the same.
Make sure the screw is not too tight on the setup station. I've noticed you can get some drag giving false readings, only screw up very lightly.

Svanur · **Posted:** Sat Mar 01, 2008 00:27:30

Thank you for quick respond. I have already check out inserts ( two times) I will do it one more time to be sure. I have these special nuts from Hudy on my set up station, well i have strong hands so it is likely that I have tight it to much :oops:

Svanur · **Posted:** Sat Mar 01, 2008 03:56:21

Well you where right

it seems like I had fault insert in outer toe in adjustment. I took it out and placed it with 0 offset insert. And no it is equal on both wheels 2.5°.....Well it should have been 3° but i don't bother. I can always adjust it later with other inserts :wink:

Now I just need to figure out,
how I could make this mistake :oops:

I worked as mechanic engineer for about 25 years and last 8 years as technical energy and engine engineer :lol:

Thanks for good instructions.

XRAY - Model racing cars

Problem with rear toe-in in my XT8

Who is online