XRAY - Model racing cars

sometimes the ball tipped on will do the job when the square tipped fail. just kinda go slow, good luck.

did you use thread lock? if so, heat it up real good with a heat gun, then dremel a slot in the head and use a screwdriver...that is what I had to do...

I use a soldering iron to heat up the screw first. It limits the heat to a more isolated area.

You can also drill out the screw head with a 3.5mm bit. Once you have seperated the plate from the bellcrank, a pair of pliers will suffice in removing the rest of the screw.

I bought a screw extracter kit that fits in a drill. It is reversed just like a regular easy out but small enough to fin in the head of the screw. I have never had to use a dremel or flat tip screw driver since i bought these.

I bought it from a snap-on tool truck.