XRAY - Model racing cars

Hope this helps.

[/img]

I have an LRP as well, but because the FUTABA receiver was too big,
I ended up changing it to a SPEKTRUM

Here are some picks.

Remember that the receiver shown is the Spektrum Micro receiver. The Micro version is about half the size of the "normal" Spektrum receivers.

Carbon motor protector: http://www.teamxray.com/teamxray/produc ... cfd7719166

Thanks Hurrle, you got them all right!!

Eppikk and Ockevin thanks.

Engine protection bar is XR303060

Thanks, Andre...!

I third that - That is some nice tidy electronics..

I have just fitted a GTB to my T2 and I have also had to mount my reciever on the Servo. I upgraded to a GTB and a Specktrum micro reciever, but unfortunatly it does not fit down the one side any more, and where am i gonna strap that big capacitor... Personally I dont like the reciever on the Servo as i thnk it looks untidy, but hey ho..

When I used to have a MRT MX Pro and a KF302f reciever it all fitted perfectly

Problem is with the GTB is that they give you 2 power cables. One is to short if the reciever is on the servo, and the other is way to long - I have colied it up with the switch wire, but not happy.. might have to get the wirecutters and soldering iron out

Damo

Thanks a lot for your comments guys.
Here are some more pictures, the battery side, and how I did to hide the long cable
of the motor.

I took some pictures of my setup, since it was for an '007, I posted in a separate thread:



Thanks,

Michael