XRAY - Model racing cars

Hi mario. The 78T would mean to get my rollout of 6.8 I would need to run a 27T pinion. Is that the smallest Xray are going to make cause at most tracks I to gear aorund 6.00 that would mean a 31T pinion.

Thats a big pinion for indoors. I know a lot of stock motors in doors suffer with big pinions. Will XRAY Consider making spur sizes from 70-77

Not being an expert on the subject of gearing am I missing a point here?
With the 84t spur we will get to our target gearing with either a 29T or 30T pinion - we use to run a 28T on the T1R and even ran a 38T for an oval race. Are 29T/30T pinions "too big" for the 008?

[quote="mario"]
* The gearing chart included with the car was printed wrongly by the printery, it is from NT1. Please download from the Knowledge base the correct gearing chart.
quote]

The only gearing chart I can find is in the doc "T2 quick ref table" and that is for a T2 not an 008. I could do a table myself but cannot find the internal ratio in either the 008 Instruction or Setup manuals. A point in the right direction please

Hi I need the answer for the the same question:

What is the internal drive ratio for the 008 EU version and US version??

Also how does one calculate the internal gear ratio??

C.