XRAY - Model racing cars

Something like .

Thanx Mini, i have the one that shows 0-15mm (i think, HUDY it is)

But wont i need something like this?

Finaly,the car showed up..thanx Jeff

Havnt decided yet, if i wil use Brus or Brushless (my Brushed scalpel is a killer) . Bought a tire truer and Arbors so i can get this right

Everything is new,newer been used..

Procar
Nya 370 motorn
LRP QC2 Micro
Micro Spectrum
Futaba Servo
Xray org Alu CVD
Xray alu mtorfäste
Xray fläns
xtrau upps Foams






Tjacka svarv,karosser o Arbors s? man f?r till pupperna..




what ya think? i have a new Mamba combo here, i will use 5 cells with BL...or should i go for 6 cells ad a cobalt? LRP?

I have had bad luck with the LRP and Reedy motors personally with smoking within the first night of use at what I thought where conservative gear ratios. I plan on trying Cobalt's next.

I hate the way brushless Mambas feel in the sedan. The Low end inst smooth/predictable. Meanwhile, I keep smoking brushed.

I will try the BL setup until i recive my Cobalt motor...

this is how it went...nothing above the motor(ex some cables)

Its hard for me to recommend from personal experience any ni-mh since I went Lipo a few years back, and haven't looked back.

If your running against insane brushless on 1/10th size tracks, probably 6-cell. If your running on smaller tracks with medium kv brushless. 5 cell would work. (IMOHO).

first test today, and only thing i cn say is...WOW!!!! the car just reach opspeed @the end of the straight, real fun to drive..ust drive,charge and drive.. little understearing out of corner(on trottle), but i fixd it, using the inner hole rear on damper, and waaaay better...

the car is REAL easy to drive..but i dont know about te servo, i think it is lttle "sauce" not fast enough...