XRAY - Model racing cars

As the name implies Im a Jammin Fan but Im about to jump ship and grab the new XT8...while I add this new truggy in my cart at www.amainhobbies.com Im courious to know if theres anything else I really need to hook this truggy up...
I have on the bench waiting:
HiTec HS5945MG T&B
HiTec HS5955TG Steering
CEO Modded Novarossi PX5 w/ Novarossi 9886 pipe & long manifold.
All I think I need is some paint and Im ready to go.
Any thoughts....all suggestions welcome.
Thank You

hi, i made the jump too. you're gonna really like the change. the truck is quicker and more nimble around the turns. not to mention the quality is outstanding! Enjoy! also, there's plenty of support which is cool!

you need this code to save $20 since I didnt get to use it due to not having subscribed to the news letter.

Your welcome,

CALPAUG25

thanks for the unput guys...and thnx whitey...I have that same code in my email box. I've bought tons o stuff from em....So you guys think the kit alone is enuff...I know some kits you want to add a couple extras to it.....you guys finding anything that may need to be thrown in the pit box or is this trug the bulletproff like the CRT??
TY Guys.

You might also wanna get the aluminum suspension holder for the front and back. The kit comes with plastics with eclip holder, which is okay, but if you want more options for your kick up and rear toe settings, then you must get the aluminum set. Remember to get the pins and eccentric bushing for the aluminum set or else it wont work.

Parts Number:

FRONT
352311 front plate
352320 Rear Plate
352315 Eccentric Bushing
357212 Lower inner Pin

Rear
353312 front plate
353323 rear plate
352315 eccentric bushings
357212 lower inner pin

.. ISS kit.. has everything you need...

I would like to jump on this also but going through that spreadsheet to figure out what parts I need is going to lead to a mistake in the order. I thought I was onto something when sneh mentioned the set, but then it says those are old parts. Is there a set for the new parts?

There is not /one/ complete set to complete the truck, it is better if you order the individual parts. I will make the list shortly...

For the complete TQ (updated suspension pieces) here are the part numbers:


352311 – TQ Front Front Suspension Holder

352320 - Rear Front Suspension Holder

352332 – TQ Front Upper Pin Holder

353312 – TQ Front Rear (Anti-Squat) Holder

353323 – TQ Rear Rear (Toe) Holder

Along with these pieces you will need eccentric pin inserts and hinge pins, unless you want to grind the stock ones down...

352315 - Eccentric Pin Inserts

357212 - Front/Rear Lower Inner Hinge Pins

Get a pack of pre-load clips as well, a pack of the 4mm shims for the arms, and a pack of eccentric bushings for spares in case you lose the kit parts. The one piece engine mount is a really good idea for the truggy since it will really reduce the amount of flex in the centre of the chassis, and there is quite a bit of flex there stock, bad for the gear mesh, but it makes the truck so nice to drive.