XRAY - Model racing cars

Hope this image helps

Hi

As indicated earlier, you need to use the supplementary short shock ends, not the ones on the sprue.

I almost made this mistake, but with the short ones and the shocks built I can put 10turns on the shock collar for the rear, 5 turns at the front and still have the ride height at 6 mm.

One thing to note (I did get caught out by this) is that these ends actually need the ball joint inserting in the opposite direction

The NT1 tech tips say insert the ball from the shiney side, and screw through from the other side - This is the way for all the other joints.

But for the shocks the Tip is the opposite You screw in from the unshiney side - This would mean that you dont get as much movement in the shock bottom, and the shock pops off the ball joint....

Sorry to digress...

Damo

Damo I will have to do another search for those supplimentary ends, I thought I was using the short ones, let me recheck


thanks

Guys I have found the small smaller ball ends, now I have to figure out how to remove the mental balls from the incorrect ends