XRAY - Model racing cars

Hi Folks,

i'm new here aboard. Since 2 Months i own a M18Pro and a M18MT, i'm very satisfied with the quality of the cars and its always a pleasure to drive them but i have the same problem with both cars. The cars doesn't run very straight, after each turn (left or right) it doesn't go back to its center position. Doesn't matter how exact the center trim is, after turning left, the center position is a little bit left and turning on the right side the center is a litte bit right. After few tries in toe-in toe-out adjustments i located the problem in the servo saver. I know the servo saver prevents the servo from damage but it isn't that excact in centering like the usual servo horns on 1/10 scale. Any suggestions?

I use a Multiplex Polo Digi 4 in my M18Pro (spektrum DX3.0) and the stock Xray Servo from the power pack in my M18MT (acoms hayabusa 40FM).

ok, i tried to use another servo horn (came with M18MT) and it works, not properly but it works rather than the servo saver.



did i made a mistake in assembly of the servo saver?