Joined: Fri Nov 26, 2004 13:34:20 Posts: 147 Location: Curitiba, PR - Brazil
|
Hi,
I think I found a problem on the instructions manual.
Carb Linkage (page 31)
The instruction show the screws on top going through the servo horn to tight on a plastic piece. But this piece had a 3mm hole and we must use a 3mm screws so the screws pass through it!
I think the right way is insert the screw on the bottom of that plastic piece and them tight it on the servo horn.
Please...... Am I right?
Help me with thins problem.
Regards to all
Flavio
FS MODELSPORT
XRAY TEAM BRASIL
|
|