XRAY - Model racing cars

Can you all tell me what technique you are using to put power to your reciever, my reciever is in the box and I cannot power it unless I take the box off attach the power then re-attach the reciever box. Also I am unable to place the power cable through the crystal hole.

Wish there was a switch

Are you all doing something different ??

Does the box has to place a switch there?? Small one that is...

Well i dont run a switch so i use the provided plug to fill that hole in.

I also run a Xray 1100mah battery pack with a red female plug on it, i have that so it comes up thru top deck in the little cut out hole just behind steering servo linkage.

Then i use another Xray product, its like a extension lead(think its like 10cm long ?) that has a Futaba plug one end and the red male plug other end same as battery. This lead goes into receiver and comes up just behind steering servo and sits on top deck.

So when i wnt to turn radio gear on i just connect both ends of red plugs and on it comes, also makes charging a breeze as battery plug is there so just plug charger into it and away it goes.

You can buy a Switch, the same size that comes with the NT18T truck, i forget Part Number for that sorry.

I also cant remember part numbers for above items, but if u wanted i could get them in a day or so, could also post pics if you wanted also.

Put this on your receiver and let the other end come out of the box: