XRAY - Model racing cars

on the front sway bar mounts there are the eccentrics adjusters .

what is the procedure for adjusting them . and what should they be adjusted at the set up manual and instruction manual dont go into these adjustments.

thanks in advance

alan

disconnect shocks and swaybar. Place car on setup blocks, measure droop. Reconnect swaybar and re-check droop. The sway bar should not change the droop levels. If it does, use ecentric adjusters to correct the problem.

On page 22 of the NT1 Set-up Book, you use the front anti-roll bar eccentric adjusters to combat front tweak.

If the front anti-roll bar is causing tweak, you adjust one (or both eccentrics to eliminate front tweak.

During initial assembly, you can orient both adjusters so they are
horizontal (pointing to outsides).