XRAY - Model racing cars

tony
what do you mean by camber gain??? and how do you adjust that???

The locater pin is directly in line with the pivot ball. I.e if the pin is inside and up then so is the pivot ball.

Camber gan, camber change, camber rise are all used to refer to the same thing, namely how much the camber angle changes when the suspension is suppressed. Camber rise (as it is referred to in the T2 setup book) can be changed by changing the lenght of the camber link (also referred to as top link) and by changing the angle of the camber link compared to the lower suspension arm.

Can you post a link to your setup?

tony i posted it on the x-ray site
here is a link hope it works
xform/index.php?act=view&ID=604&setup=t2_007
Chris08527 track jackson rc
for some reason i cant post the link
can you just do a search on the set-ups page???
thanks
Chris

hey tony
basically did everything you suggested to the car except change the ackerman angle becuase i wasnt sure if you wanted me to do it thought he steering block or the servo saver???
the car was much better had steering, little bit of the rear end loose thing was me over driving the car . . .forgot carpet season is over
now if i really wanted to be picky the car felt a little tight with fresh tires
can you take a look at set up #2 and make any suggestions
thanks
Chris

Chris, what do you mean exactly when you say the car felt a bit "tight" on fresh tyres?

can didnt want to rotate
the car was very good but i think it could be a little better