XRAY - Model racing cars

Hi,

I also usually run on a tight carpet track, stock motors and rubber tires. I did a good deal of testing last meeting and ended up with a setup very similar to the one posted above, except for running 40wt oil in the front shocks.

However, I would get this down to 30wt and go up one spring all round as the track was VERY small (10 x 15m) and tight.

Are you allowed other tires and additive? The tire of choice at my track is the CS22 with the insert that comes with them when you buy them glued up. Oh, and plenty of additive too! T27s can work if your club ban additive ( ), just run a slightly firmer insert in the front would be my advice.

James

Front
Jaco purple/orange foam tires
3 deg c-hubs
33 lbs springs
40 wt oil two clicks on the adj shocks
all the way out on the shock mount
med on the diff
center center on the kickup
2 neg camber
0 deg toe
camber link stock

Rear
Jaco purple
28 lbs springs
40 wt oil three clicks
all the way out on the shock mount
hard on the diff
center center on kickup
2 neg camber
2 deg toe
camber link stock

I hope this helps. This is a good basic med traction setup for carpet.