XRAY - Model racing cars

YES-BLADE did and i got it from another guy. i just got me a web host so im trying to get it on here right now. im doing it to mine today.

now this is how you should do it men.

Z-Man, did you just take material off one side of the C-Hub or do both sides need it!

Does it give you the same effect as doing the mod to the arm??

Here's a comparison of all kinds of springrates from different brands.
Paco the site owner will be adding the rates for the xray springs soon.


Z-man,
thanks for the pic.

Ya, found out Greys are stiffer than the Blues. I'll be searching for the Blues now. Thanks guys.

BOOYAH- yes you take it off both sides and i think it gives you a better result than trimming the a-arms. you would have to take quite a bit off to get the droop you need on the arms. now how i set mine is when you are shaving(you dont have to take the tie rods off)- test it by putting the bottom pin in and when you have to put the top arm on, the hole should not have to go very far to put the screw in. it should almost line up w/ out having to raise it up much at all. you want it to a little so the shock piston dont support all the weight and break.if you take too much off set the droop screws properly.