XRAY - Model racing cars

Yes, that should help and will also help when accelerating out of corners. Definitely worth a try. Wonder why I did not think of that one

for anyone that may be following this..
I reduced the toe-in and found that the high speed corner could be taken at full throttle. The car did become rather loose though so i will try and increase the toe a small amount to 2.5

MAJOR MAJOR difference now check out my sheet

http://www.teamxray.com/xforum/xform/in ... tup=t1fk05

made some changes again mainly reduced rear toe from 3 to 2 degs
changed front springs to 30lb and rear 15lbs
also cut the top deck as mario hudy stated in his article .

unbelievable difference it swished through the corners like a knife including thew 270deg corners that where in this track...

no over steer and most certainly not the same car from a few weeks ago
no push at all very piontable now ........

all i need to do now is gain a little confidence with this setup and i shall be away with the A's