XRAY - Model racing cars

I have recently installed a multi diff on my T1 Evo2 & when I run it in the full time solid postion (which I find awsome) The front screws in the wheels keep coming loose, any ideas on how to fix this problem would be most welcome. Thanks.

tighten them harder or a small amount of blue loctite, personally i have never had any come loose

again the name of the thread does not correspond with the content.

I changed the name of "full time solid" to "T1FK05 Wheel screws get loose using full time solid axle"

Be sure your front wheel washers are fitted right side outside.

You can install also the optional

Hi

i have had this problem alot with the o5 the problem is that through constantly undoing and re tighterning the screws and washers the washers compress from a cone shape when new to a flat ring this is what causes wheels coming off in races the cure i have found and works really well is go down to b&q or local hardware store and ask for some m4 split ring washers they are fantastic you wheels may come a little loose during the race but will stay on for the full 5 minutes without any problems

I hope this has helped you
Ben

never had a problem with the cone washers using the spring steel wheel hubs try them. their stronger also. wheel nuts are ok on the t2 but they do stick out a bit when using foams.

Also make sure you really (and I mean really) tighten the screw. I have raced every XRay touring car from the original T1 all the way through to the new T2 and have only had one wheel come loose in 5 years time. The wheel screws are the one set of screws on the older cars that you can and really should tighten really fast.