tq set: rear toe in

Kristof · **Posted:** Tue Feb 14, 2006 01:25:27

hi guys

Can you give the car more than 2° rear toe in with the tq parts or did i need use the old back plate 2°-4°?

Greetings

Casper · **Posted:** Tue Feb 14, 2006 01:36:52

Use the alum rear hubs to get 2 deg out there.

Astroracer · **Posted:** Tue Feb 14, 2006 13:15:17

I think the rear plate included with the TQ set allows 1.5 - 3.5deg of toe-in, as it comes set with 2.5deg with the 0 bushing which means you could go 1deg either side of that.

I'm sure somebody will correct me if i'm wrong :wink:

Stanley Wangsanegara · **Posted:** Tue Feb 14, 2006 17:55:52

Astroracer · **Posted:** Tue Feb 14, 2006 19:07:04

Stanley Wangsanegara · **Posted:** Wed Feb 15, 2006 08:14:00

Hi Astroracer,

Honestly I never try it in the set-up. I just measure TQ set rear place the distance between the two holes and compare it with the original 2-4 degree plate. The distance between the two plate is the same. So, I tought that it is intentionally made as 2-4 degree block.

It might be the bushing in your front plate (Rear Gear Box) already have too much slope so that the degree reading is not correct. Maybe.. Just Maybe..

guy02 · **Joined:** Sun Apr 10, 2005 20:42:34 **Posts:** 402

XRAY - Model racing cars

tq set: rear toe in

Who is online