XRAY - Model racing cars

[quote="SuperXRAY"]I don't really understand the confusion, as the setup sheets clearly shows where it goes. [quote]

Yes you would think that but it was not the case

It is now clear. The positions on the set-up sheets show where the servo saver stand is positioned, not where the tab is.

I agree the set-up sheet did not explain it clearly enough and some confusion could happen (which also happen) but nothing so bad happen. The set-up book will be fixed for next batch, online version will be fixed in few days and the set-up sheets will have a comment to explain this in next version. It is just a progress to make good things even better.

The on-line T2 set-up sheet has now been updated and some minor bugs were fixed. Now it should be working all ok. If there will be any other issues you will find, please post here.

Otherwise enjoy the special and exclusive service of on-line virtual set-up sheet database provided only by XRAY.

Found a small problem in the T2 on-line sheet.
I use the ALU rear upright with 2 degrees outboard toe in and NO shim for inboard toe. But in the sheet I must select a inboard shim. There should be a zero choice for inboard shims in the rear.

Mario,

I don't know if you aware of this:


(I know it shouldn't be a seperate thread, but I couldn't rearrange it )

Thanks in advance.
Gr. Joep

Just tested printing with a Kyocera Mita FS-3800 and the issue did not occur. So it is for sure the printer (memory).

OK, we will analyse and see what is the problem. The memory of printer may be the problem, since I have no problems to print anything.

Dear Mario,

Can you upload the setup use by team xray for the above event? I like to compare and maybe try out their setup for my local race. I race most of the time on asphalt.

TQ and rgds

Mario, FYI: I've printed some larger PDF files recently (over 25 mb in size) and had no problem whatsoever with printing them on my own configuration. And printing the '05 setup sheets works also fine.
Maybe the issue is in the amount of 'choices' and buttons in the T2-sheets?

We spent few days on reprograming some codes and reworked the PDF's and hopefully found the source of the problem. Now it seems that the printing has been solved, please try to download some set-up and to print it. We have had no problems with printing at our side and even the set-ups worked in the Acrobat version 5. But for proper working we still suggest at version at least 6 and optimally the version 7. Remember that the reader is freeware which you can download from www.teamxray.com

We have been still working to optimise the size of the file to be a bit smaller. The modifiable set-up sheet for download will be replaced too in the next few days.

Thanks for the feedback.

Mario,

I've tested the new on-line version and also the "The modifiable set-up sheet for download" which I tested last week. And all works fine now.
This is what I love about Xray. Feedback can not only be given, but also something good comes from it