Hi everyone!
I had little accident on race track and I allmost cry when I saw my personal transponder with cutted wires very near ponder casing
![Crying or Very sad :cry:](./images/smilies/icon_cry.gif)
. Ok after first shock I resolved this with little trick...
I just replaced that lid which is same side than wire with piece of circuit board with using of CA glue. Then I welded short wires which was left on ponder to it.
Now I dont have to worry about cutted wires anymore because I can easily replace wiring again.
I hope someone else can use this trick...
Oh, and the picture