XRAY - Model racing cars

Eyeball....... i dont mean to ruffle any feathers here.... But if you look at ralph burch's set up sheet, where he has the droop settings. it specifically says front droop mesured under screw of c hub. And rear droop is mesured under BLOCK......





when i was explaining this to cbcbcb i was refurring to the rear of the car (block) not the front. As what we were clearly discussing in an earlyer post





If I am wrong it is beacuse i am using these setup sheets as my reference...

Alberto, you're not wrong in any way if you're following someone else's setup sheet as that will be the true measurement obviously, and you're not ruffling any feathers either.

I was just under the impression that you were supposed to measure under the screws but in actual fact, looking at the FAQ it does say drivers will post where the measurement was actually made, so my apologies.

S