XRAY - Model racing cars

next time you could also try a light blue spring in the front.

And Chaz is right: the set-up book what came with the kit is very good to work with.

I'm running white springs alround with a spool. Using CS22's on high grip surface though. If u can try some 22's should be quicker with higher wear rate.

Rear droop should be around about 6mm under the wishbone.

Car seems to like harder damping. Original Fk worked with 35 wt oil and 4x1.2mm holes. New car seems to grip about the same with 30 wt and 3 holes.

Mark

Yes, the team is converging on 3 standard holes with 30w oil too.

Sorry danno, didnt realise u were from florida. Your right dont think 22's are an option!

6mm under the wishbone should give a fair amount of uptravel using the middle roll centre holes on the inner wishbone pickup points.

Just read your 1st post again. Sounds like your rear diff might not be set right. With the spool in the front, get someone to hold you front wheels, and try turning both rear wheels forward with one hand on each wheel. You should just feel the diff slipping and no more.

Hope this helps!

I ran this past saturday and OMG, the car was perfect, I ran the light blues up front and changed rear droop in rear to 6 off the arm, and the car was money!! I set TQ and was the only one to turn a 9 sec lap. . I tapped a pipe in the main and ended up second. Thanks to all for their input, and xray for a great ride..L8tr
Dan