XRAY - Model racing cars

What a fantastic bashing buggy!! I went with 6s and get around a 30 minutes run time 5200mAh, 15T pinion, 47T spur, 1550kv motor and 60% throttle end point (close to 50mph). I thought I would be fabricating a handful of various parts to increase reliability and performance. That was not the case, however I did find one area that did need improvement. It is the rear shock tower brace. It is a vital part if you do a lot of jumps. The problem is that it is composite where is connects at the tower sub-structure and the tray The material suffers from repeated impacts and gets loose where the screws hold it in place. After a couple of hour of jumping I grabbed the buggy by the front and rear shock towers and moved them in an out. The rear one had about a half to one mm of play that could not be adjusted or tightened out. I could feel the rear tower 'notching' back and forth. I made a replacement out of 7075 Al and kept tolerances extremely tight. Now it is rock solid and completely rigid.

Anyone make any other items to improve the overall vehicle?

Hi buddy, to be frank there is nothing much that can be done rather than tuning the speed-o-meter.

Regards,
Hahu Smith

The custom made parts of any racing car are very expensive. In my opinion, the car parts should be bought not from the online market but the physical market . I hope this helps while buying the car parts.

Bashing buggy is the racing car and is very fast and expensive. If guanine parts of the car are damaged, its unfortunately not easy to find them. bashing buggy look very beautiful. Nothing is impossible in the world to get any thing but first take a step to grow your then After We Earn handsome money and then fulfill the dreams and purchase any anything Like fantastic bashing buggy.