XRAY - Model racing cars

I bought a Hudy fully automatic truer a few weeks before the Beijing worlds.
I know Greg Hill at RC Disco had been in contact with yourselves.

He sent me one of the latest batch yesterday, but this also has the same problem, where the main motor will not turn in one direction.
I have attached a link to video of the fault;

Hi Skiddins,

please, check the instruction manual for 102003 tire truer - http://www.hudy.net/xhudy/showfile.php? ... 2d0e4ab575. The left side power switch in position one - diameter grinding (step 5.1 in the instruction manual) - does not start the operation, it only prepares truer for diameter grinding. The operation itself starts with moving the right side power switch - support - to the position 1 (alt. 2) (step 5.2 in the instruction manual). When grinding the diameter, there is no need for wheel to turn without support movement (right power switch in middle /0/ position). Hope I clear things out now.

Ok thanks

I had read the instruction sheet, but didn't understand from the sheet that the left switch doesn't directly turn on the motor in that direction (as it doesn't tell me that), it mentions automatic trueing but I thought that just mean't the operation of the slide.

Unit appears to work fine

Thanks

Great!

Don't know about the carbon fibre parts, but the rear axle is adjusted vertically by screws, you then put shims between the two parts to move the axle up or down. A *little* bit like the CRC, but the adjustment is on top, not the rear, and the motor screws are only at the bottom, like the T4's Presumably still in testing, but I would expect bits of it to end up on the next car.

This week we have sat down with our good friend Martin Hudy, son of Juraj ... made his own tools, tire truer and all the accessories he needed and he had to ... I answer to all important emails and I add “to do” e-mails into my task list. ... With all the team, work on the projects needs to be fully automated.
https://customerfeedbacks.info/