XRAY - Model racing cars

Well , got my new car build last night , like all new parts , BUT

Seems like there has been a mistake with the rear battery stop on the inside against the belt. If you use the flex options you can not place the optional stop with the left servo mount and some shims. You can also not use the nut as on all the previus T4 cars as the hole has not been drilled in the chassis.

I have used the speedo capasitor placed abow the belt , so it placed between the battery and the speedo.

The front one on the right servo mount works Great.

Did I miss something in the build or is it a mistake?

I don't have the new car yet.
But I have run that centre link on the '16.
I put a nut through the hole that's almost under the belt to act as the rear battery stop.

Hi

As you can see on picture , that hole is not on the 17 car

Well , picture comes later ,

Attached is a pic of a friend's T4'17 that he is about to race at IIC this week. Seems to be a decent solution

Agree BUT then you remove some flex because of the battery stop.

Well , lets see some more ideas or maybe a reply from Marin Hudy , i think a pladtic stop of some kind using one or 2 of the flex holes without touching the flex bar

What about using the optional adjustable lipo battery stops, and puting the rear 'L' bracket facing inwards instead?

Scrap that, would foul on the layshaft mount

In that case, I might be going with the 'piece of carbon Shoe Goo'd' to the chassis'

This is my X12, to stop the lipo moving forward but you get the idea;

Hi Skiddins

Looking good , have you just super-clued the carbon piece on the chassis ??

Some of the danish drivers have used a 5g weight from balancing a car-wheel.

Lets hope that there will be a new part to be mounted on the chassis

thanks Michael