XRAY - Model racing cars

Hello,
I’ve a problem with the eccentric bushings. Do you have a list with all possibilities?
With this eccentric bushings you can adjust rear squat, rear toe-in, rear roll center and rear track-width.
So I want to have two degrees rear toe-in, rollcenter at RR down and FR high.
The T4 2013 and the T3 are very simple to adjust, T4 2015 ist a little bit complicated form e.
Can you help me?
Thanks.
Chris

Hi Chris,

There should be an image in the manual that shows the possibilities. From what you're describing it sounds like you want the .5 insert with the dot in the corner to be down and in on the rear/rear mount, and the same insert with the dot up and out on the front/rear mount.

Edit: I found on page 14 of the manual there is an image displaying the possible settings, though it doesn't provide detailed info. Basically .5 on the insert is approximately equal to .5 degree, and 1 is approximately 1 degree. So by doing the above you should end up with about 2* rear toe and about 1* of rear anti-squat.

Thanks for your help.
Yours Chris