XRAY - Model racing cars

A question for Alexander Hagberg.

In some of your setup sheets, you have rear toe in specified as e.g. 2.2 or 2.7.

How do you gain that. Thought using the inserts would change the toe in 0.5 increments.

Thanks!

Basically standard toe is more close to 3.3 degrees and not 3 as on previous models.

If you decrease toe by adjusting suspension pin inserts by -0.5 then you will have approx 2.7 degrees of rear toe.

If you go -0.5 further, you will have 2.2 degrees of rear toe (approx again).

OK, I understand, thanks for the reply.