XRAY - Model racing cars

Hi all,

where exactly can i find a copy of the T4 Setup Book?

thanks in advance.

Look at the downloads section in the T4 part of the main Xray website

There is no t4 book is there? I thought the t3 was adequate or not enough changes to warrant a new book, shame u don't get 1 in the kit though.

There is no setup guide under T4 downloads.

There are setup sheets, no guide.

There is the instruction book that came with the kit, but I'm after the setup guide.

I didn't have the T3 so no good there.

Can someone please help here. PDF copy is fine.

I've never owned a T3.

Where can I get a copy of the setup guide?

You will get a T3 Set-up Book here:

http://www.teamxray.com/teamxray/produc ... 0&catName=

If this link doesn't work, go to TeamXray web site, select "T3R" car and then "Downloads" where you will see a PDF for the T3 Set-up Book in English and in Polish

If you can still cannot find that then the T2 setup book is basically the same except the T3 book has a picture of a T3 on it. I did notice the word T3 used somewhere but cannot see any changes - eg it does not refer to the new inner camber link positioning on the T3 nor the quick ackermann adjustment on the inner link mechansm.

At the end of the day there are really no differences as far as the setup book is concerned, just how you achieve them and what to set them to, which is covered by the setup sheets.

Set up book for T4 is same as for T3 and is available in the download section here http://www.teamxray.com/teamxray/produc ... tName=XRAY T4

I just read the book, and it answers just about any question I've had regarding setup.

I think I've found an error though:
The "Toe" section, page 18.
The table says about front toe that More toe-in increase "nervousness" and makes the car more difficult to drive. And then the opposite for toe-out.

All other sources I've seen/read state that toe-in makes the car stable when going straight and toe-out makes it "nervous", which is also well inline with the understeering of toe-in and oversteering of toe-out.

Comments?

Hi all,
still think that they should update the T3 setup book with the new setup options like flex, ARS, insert positioning material stiffness and so on

Best regards

An update would be nice, to make it cover all T3 and T4 versions.
Just incorporate notions where there are differences between the chassis (T3, T4, T4'14 and T4'15) and how to adjust the settings for each version.

I have a T4 (1st version) and for example the inner Ackermann setting seems to differ from that of the T3, in a way that isn't clear to me.