XRAY - Model racing cars

Hello, i would like to know how to drill holes in the body.To get more front grip should be placed ahead or behind? Like setting according to the grip of the asphalt track?
Thanks and excuse my english!!

For more from grip you will want to move the body forward. So your holes would be behind your normal ones, as in closer to windscreen.

Ok, as recommended to drill? Do I usually coincide pin ecs front passes in the middle of the skip wheel

Using the factory scribed wheel cutouts on the ltc-r, I measure to make a center line between them. This photo shows current position on my car that about 2.75mm forward from centerline. This is for a lower grip carpet. It is only slightly more aggressive than center mounted position. You can try 5mm forward and see if it helps.




Alexander should be back in a day or 2 and tell us what he did for the ETS race.

ok ,thank you very nice!

This is how I measure it. The center of the body post to the bottom edge of the front windscreen. I usually mount my body quite a bit forward for more steering overall. I use these measurements:

LTC-R: 74.5mm
SP6: 71
GX: 74.5

ok,thanks!!

Hi Alex, do you have a similar measurement for the new Dodge Dart bodyshell?

And I would like to add to the question to Hagberg, does the measurements still apply for the 2015 version, as I suppose that the measurements given here are for the 2014 version.